检测到您已登录华为云国际站账号，为了您更好的体验，建议您访问国际站服务网站 https://www.huaweicloud.com/intl/zh-cn
不再显示此消息
检测到您已登录华为云国际站账号，为了您更好的体验，建议您访问国际站服务网站 https://www.huaweicloud.com/intl/zh-cn
不再显示此消息
Why Does Error Code 500 Is Displayed When I Create a Gateway? Symptom When I deploy Bookinfo in one click, a message is displayed, indicating that the gateway fails to be created. Fault Location Log in to the ASM console, press F12, and switch to the Network tab to view APIs.
What Do I Do If an Added Gateway Does Not Take Effect? The possible cause is that the Gateway-related resource configurations are missing or incorrect.
Authenticating JWT Requests on the Ingress Gateway Using ASM This section describes how to authenticate JWT requests on the ingress gateway using ASM to ensure that users access services through the ingress gateway with a reliable access token.
Gateway Workloads Rolling Upgrade Policy Graceful Pod Deletion Scheduling Policies Container Resource Requests and Limits Parent topic: Istio-ingressgateway HA Configuration
How Do I Configure max_concurrent_streams for a Gateway?
Gateway Services Service Affinity Load Balancer Health Check Parent topic: Istio-ingressgateway HA Configuration
Parent topic: Gateway Management
Adding a Gateway A gateway enables unified entry, traffic management, security, and service isolation. Prerequisites Gateways use load balancers of ELB to provide network access. Before adding a gateway, you need to create a load balancer.
In the navigation pane, choose Gateway Management. Then, click Add Gateway in the upper right corner. Configure the parameters in the window that slides out from the right. Configuration Information Gateway Name: Enter httpbin.
Parent topic: Gateway Services
During adding a route, the target service is filtered based on the corresponding gateway protocol. The filtering rules are as follows: For an HTTP gateway, select an HTTP service. For a TCP gateway, select a TCP service. For a gRPC gateway, select a gRPC service.
Gateway Management Adding a Gateway Adding a Route
The authorization takes effect permanently. asm_admin_trust contains the following permissions: EPS FullAccess, ELB FullAccess, Tenant Guest, CCE FullAccess, AOM FullAccess, VPC FullAccess, and NAT FullAccess.
Service Mesh Events Scenarios ASM supports the event center, which allows you to query details about important operations such as service mesh creation and deletion and gateway creation and deletion. You can view events in a Basic service mesh of 1.8 or later in ASM 1.0.
Check the gateway settings. (This check is not required for 1.8 and later versions.) In 1.8 and later versions, the gateway listening port number must be greater than 1024. If your gateway uses a port number smaller than 1024, change the port number. Check component affinity.
Parent topic: Gateway Workloads
Parent topic: Gateway Services
Run the iptables iptables –t nat –L –n –v command to check whether the configurations take effect for specified IP address ranges and ports. Parent topic: Managing Traffic
Parent topic: Gateway Workloads
Adding an IPv4/IPv6 Dual-Stack Gateway Log in to the ASM console. On the service mesh list page, click the name of the service mesh with IPv4/IPv6 dual stack enabled. In the navigation pane, choose Gateway Management.
