检测到您已登录华为云国际站账号,为了您更好的体验,建议您访问国际站服务网站 https://www.huaweicloud.com/intl/zh-cn
不再显示此消息
On the VPN Connections tab, make a note of the local gateway for changing the value of the remote gateway of the VPN gateway in AP-Singapore.
Source address: On-premises tunnel IP address (200.51.51.100) Destination address: Tunnel IP address on the cloud (192.168.0.98) Tunnel VNI: 5530 For details about how to configure on-premises switches, see Configuring a Tunnel Gateway in Your Data Center.
For details, see Configuring a Tunnel Gateway in Your Data Center. The Direct Connect or VPN connection fails. Check the Direct Connect or VPN connection configurations. Direct Connect Network and Connectivity VPN Connection or Ping Failure
Step 4: Configure a Tunnel Gateway in Your Data Center Scenarios This section describes how to configure the tunnel gateway on a VXLAN tunnel switch of an on-premises data center. The following uses Huawei CE6850, Ruijie RG-S6250, and H3C S6520 series switches as examples.
For details, see Configuring a Tunnel Gateway in Your Data Center.
An enterprise switch is a tunnel gateway of a VPC and corresponds to the tunnel gateway of your data center. It can work together with Direct Connect or VPN to enable communications between a VPC and your data center at Layer 2. Figure 1 shows the networking diagram.
If Tunnel Connection is set to Direct Connect or VPN, the VPC is set to the one that the Direct Connect virtual gateway or VPN gateway belongs to by default. vpc-01 Tunnel Subnet Mandatory Subnet of the VPC that the enterprise switch belongs to. It is the local tunnel subnet.
On-premises servers cannot use advanced network functions on the cloud, such as VPC Peering, Route Table, ELB, and NAT Gateway.
in Your Data Center This section describes how to configure the tunnel gateway on a VXLAN tunnel switch of an on-premises data center.
If Tunnel Connection is set to Direct Connect or VPN, the VPC is set to the one that the Direct Connect virtual gateway or VPN gateway belongs to by default. vpc-01 Tunnel Subnet Mandatory Subnet of the VPC that the enterprise switch belongs to. It is the local tunnel subnet.
Remote tunnel IP address (200.51.51.100) and tunnel VNI (10001) 4 Configure a tunnel gateway in the on-premises data center. Configure a tunnel gateway on the remote VXLAN switch to establish a VXLAN tunnel for the remote Layer 2 connection subnet (Subnet-layer-R01).