检测到您已登录华为云国际站账号，为了您更好的体验，建议您访问国际站服务网站 https://www.huaweicloud.com/intl/zh-cn
不再显示此消息
检测到您已登录华为云国际站账号，为了您更好的体验，建议您访问国际站服务网站 https://www.huaweicloud.com/intl/zh-cn
不再显示此消息
How Do I Set the Number of VPN Connections When Buying a VPN Gateway? A VPN connection is an IPsec connection established between a VPN gateway and an independent public IP address of an on-premises data center.
Do I Need to Configure ACL Rules on the Console After I Configure ACL Rules on the On-premises Gateway Device? You need to create ACL rules on your on-premises gateway device. The ACL rules will be referenced by IPsec policies.
If you create another connection for the gateway, you will be charged for the additional connection. The IP address of the VPN gateway will not be billed. A VPN gateway cannot share a bandwidth with an EIP bound to an ECS. Parent topic: Product Consultation
How Do I Select a Proper Region on the Cloud When I Am Buying a VPN Gateway? You can select a VPC in any region when you buy a VPN gateway. But it is recommended that you select the region where your on-premises data center locates for lower network latency.
[AR651]ip route-static 0.0.0.0 0.0.0.0 1.1.1.254 In this command, 1.1.1.254 is the gateway address for the AR router's public IP address. Replace it with the actual gateway address. Configure routes to the active EIP and active EIP 2 of the VPN gateway.
[AR651]ip route-static 0.0.0.0 0.0.0.0 1.1.1.254 [AR651]ip route-static 0.0.0.0 0.0.0.0 2.2.2.254 preference 100 In the commands, 1.1.1.254 and 2.2.2.254 are the gateway addresses for the AR router's public IP addresses. Replace them with the actual gateway addresses.
Changing a Pay-Per-Use VPN Gateway from Being Billed by Bandwidth to Being Billed by Traffic or the Other Way Around Prerequisites A VPN gateway is billed in the pay-per-use mode. The billing modes available for a region are subject to those displayed on the page.
Increasing or Decreasing the Connection Group Quota for a Yearly/Monthly VPN Gateway Scenario You can increase or decrease the number of connection groups for an Enterprise Edition VPN gateway whose specification is not Basic. Procedure Log in to the management console.
Ensure that the on-premises gateway supports IPsec VPN. Create a VPN gateway and a VPN connection on the cloud. Select the VPC to which the Direct Connect connection uses for the VPN gateway.
Only one VPN connection can be created for each VPN gateway of the earlier edition and its bandwidth is not guaranteed. You can delete the gateway and create one of the new edition. But services will be affected.
leftnexthop=22.22.22.1 # In the NAT scenario, enter the post-NAT gateway IP address. right=11.11.11.11 # Set the VPN gateway IP address. rightid=11.11.11.11 # Set the ID of the VPN gateway.
Do I Need to Configure ACL Rules on the Console After I Configure ACL Rules on the On-premises Gateway Device? You need to create ACL rules on your on-premises gateway device. The ACL rules will be referenced by IPsec policies.
Do I Need to Configure ACL Rules on the Console After I Configure ACL Rules on the On-premises Gateway Device? You need to create ACL rules on your on-premises gateway device. The ACL rules will be referenced by IPsec policies.
The resource quotas of a yearly/monthly VPN gateway can be decreased upon a renewal. Confirm the VPN gateway information, set a renewal duration, and click Pay.
N VPN Gateway VPN gateway that has been created. N Identifier IP address used by the customer gateway to communicate with the VPN gateway. The value must be a static address.
Operation Scenario Typical networking shows the typical networking for connecting a Huawei Cloud VPN gateway to a Tencent Cloud VPN gateway using static routes.
Packet Loss Occurs During Service Access Symptom A client is connected to a P2C VPN gateway, but packet loss occurs during service access. Possible Causes Service traffic bursts or continuously exceeds the bandwidth of the VPN gateway instance.
If the HA mode of a VPN gateway is active/standby: The outgoing traffic from the VPN gateway to the customer subnet is preferentially transmitted through the VPN connection set up between the customer subnet and the active EIP.
Only one VPN connection can be created for each VPN gateway of the earlier edition and its bandwidth is not guaranteed. You can delete the gateway and create one of the new edition. But services will be affected.
The P2C VPN gateway list is displayed. Locate the row that contains the target VPN gateway, and choose More > Change VPN Connection Quota. In the Change VPN Connection Quota dialog box, select Increase or Decrease, and click Yes.
